- Coaxial speakers mount the tweeter on the woofer, so they drop into the factory holes. They are the easy, affordable upgrade.
- Component speakers split the woofer, tweeter and crossover. That allows better tweeter placement and usually better sound, but the fitting takes more work.
- Match the speakers to your stereo: with a factory radio look for sensitivity above 90 dB, and with an amplifier check the RMS power rating.
Swapping the factory speakers is one of the most worthwhile car audio upgrades, and the first choice you face is the type. Coaxial and component speakers both fit the same door openings, but they behave differently once they are installed. Here is how to pick the right one for your car.
What is the difference?
A coaxial speaker, also called a full range speaker, packs everything into one unit. The tweeter sits on top of the woofer, and a small built in filter sends the highs to the tweeter. A component set separates the parts: a woofer, a separate tweeter and an external crossover that splits the signal so the woofer gets the lows and the tweeter gets the highs.
Why component speakers can sound better
The main advantage is where the tweeter can go. High frequencies are directional, so a tweeter mounted higher up, on the door corner, the A pillar or the dash, points closer to your ears. That tends to give clearer vocals and a wider soundstage than a tweeter sitting low in the door. The separate crossover also divides the frequencies more cleanly between the two drivers.
If your car already has factory tweeters, the new ones can often go in the same position, which keeps the work simple.
Which one is easier to fit?
Coaxial speakers win here. The old speaker comes out, the new one goes in, and a wiring adapter keeps the job reversible. A component set needs a few more steps: mounting the woofer and tweeter separately, finding a dry, secure place for the crossover, and routing extra wiring through the door. Tweeters can be flush mounted, surface mounted or fitted in the factory location, and some come with angle mounts so you can aim them slightly.
Match the speakers to your stereo
Two numbers matter. Sensitivity tells you how loud a speaker plays for a given amount of power. With a low powered factory radio, which often delivers around 10 to 15 watts RMS per channel or less, look for sensitivity above 90 dB. With an aftermarket stereo or an amplifier you can use speakers with lower sensitivity.
RMS power handling tells you how much continuous power the speaker can take. Ignore the peak figure. With a factory radio, a low RMS rating is fine. With an aftermarket stereo and no amplifier, keep it at or below about 75 watts RMS. If you add an amplifier, match the speaker RMS rating to the amp output in its manual.
So which should you choose?
- Choose coaxial if you want a simple, affordable improvement over worn factory speakers, you are fitting them yourself, or you want to keep the job easy to undo.
- Choose component if sound quality and stereo imaging matter most, you are comfortable mounting tweeters and a crossover (or paying a fitter), and you plan to add an amplifier.
Do not skip the basics
Check the speaker size and mounting depth for your car before you buy, because a speaker that is too deep can hit the window mechanism. New speakers also work best in a quiet door, so a little damping goes a long way. If your sound is already distorting, fix the cause first.
Sources
- Crutchfield: Car speakers buying guide
- Crutchfield: Component car speakers and tweeters installation guide
Comments